Toyota RAV4 > Fuel and exhaust systems > Fuel pump control module — replacement

Fuel pump control module — replacement

Note: The Fuel Pump Control Module (FPCM) is located in the rear of the vehicle, on the driver’s side behind the quarter trim panel. On vehicles built before 10/2015, the FPCM is located on the floor of the vehicle. On vehicles built 10/2015 and later, the FPCM is on the side of the vehicle, just rear of the seat belt retractor.

1. Remove the driver’s rear floor trim and carefully pull back the quarter trim to access the FPCM (see Body).

2. Disconnect the FPCM connector (see illustration).

i. 2 Identifying the FPCM (vehicle built prior to 10/2015 shown)

Toyota RAV4 Fuel and exhaust systems | Fuel pump control module - replacement _ Identifying the FPCM (vehicle built prior to 10/2015 shown)

3. Remove the bolt and remove the FPCM from the vehicle.

4. Installation is reverse of removal.

  • Pages

    open all | close all