Starter motor — removal and installation
1. Disconnect the cable from the negative battery terminal (see Troubleshooting).
2. Remove the battery, battery tray and reinforcement (see Battery — removal and installation).
3. Remove the terminal cover and disconnect the electrical connectors from the starter/ solenoid (see illustration). The B+ terminal cover can be easily removed by inserting a screwdriver into each slot (on the face of the cover) to disengage the tabs.
i. 3 Disconnect the positive (B+) terminal (A), then disconnect the starter electrical connector (B)
4. Remove the two starter motor mounting bolts (see illustration). Remove the starter motor assembly from the engine compartment.
i. 4 Remove the two starter mounting bolts
5. Installation is the reverse of removal. Tighten the starter motor mounting bolts to the torque listed in this Chapter’s Specifications.