Camshaft Position (CMP) sensors — replacement
Note: The CMP sensors are located on the top rear (driver’s side) of the valve cover. See Variable Valve Timing-intelligent (VVT-i) system — description and component replacement for information regarding the camshaft VVT (variable valve timing) system and VVT oil control solenoids.
1. Make sure the ignition key is in the Off position.
2. Remove the engine cover.
3. The sensors are mounted at the left end (driver’s side) of the valve cover (see illustration).
i. 3 Location of the Camshaft Position Sensors
A Intake Camshaft Position Sensor
B Exhaust Camshaft Position Sensor
4. Disconnect the sensor electrical connector, remove the mounting bolt and remove the camshaft position sensor from the valve cover, pulling it straight out.
5. Installation is the reverse of removal.