Instrument cluster
Warning: The models covered by this manual are equipped with a Supplemental Restraint
System (SRS), more commonly known as airbags. Always disable the airbag system before working in the vicinity of any airbag system components to avoid the possibility of accidental deployment of the airbag(s), which could cause personal injury (see Airbag system — general information). Note: Before disconnecting the battery, allow the car to sit (undisturbed) for approximately one minute. This will allow some of the various modules to go into their sleep mode.
1. Disconnect the cable from the negative battery terminal (see Engine electrical systems).
2. Remove the center trim panel from the instrument panel (see Body).
3. Remove the instrument panel vent registers (see Body).
4. Remove the instrument cluster bezel trim (see Body).
5. Remove the cluster mounting screws, then pull outward to release the instrument cluster from the lower clips (see illustrations).
i. 5a Remove the two mounting screws from the instrument cluster
i. 5b Guide the cluster out, then disconnect the electrical connectors
6. Installation is the reverse of removal.